 |
Photography by Eric Paradis || Process by Noos
INITIALIZE HARDWARE SETUP
|
INITIALIZE ALL EXP PEDALS ZOOM ControlONE FCB1010 CALIBRATE ZOOM EXP PEDALS 1.Holddown PEDAL 1 SETTING while Power ON 2.Fully close P1 then STORE 3.Fully open P1 then remove feet then STORE 1.Holddown PEDAL 2 SETTING while Power ON 2.Fully close P2 then STORE 3.Fully open P2 then remove feet then STORE 4.Enable P2 stopper then press STORE 5.Disable P2 stopper then turn P2H fully RIGHT then STORE CALIBRATE FCB1010 EXP PEDALS 1.Holddown FS1+5 while Power ON 2.Fully close EXP.A then UP/ENTER 3.Fully open EXP.A then UP/ENTER 4.Fully close EXP.B then UP/ENTER 5.Fully open EXP.B then UP/ENTER |
XIOsynth
__________________________________
AA.
VolumeKnob=max MODE=Xiosynth
IF the XIOsynth happens to become,
PITCHWISE, OUT OF SYNC, recalibrate: Xiosynth GLOBALS Global > Cal Pitch/Mod G510
______________________
DISCONNECT/RECONNECT
ComputerKeyboard G510 KUSTOM
______________________
PRESS Footswitch 2 TIMES
'KAC-FS100 EFEECTS' [this sets it to OFF] |
TUNE GUITARS ... ANY STRINGED INSTRUMENTS STEIN C F C=C G C MESCALITO WYNGZ F(bass string) C F C G C |
TURN UP VOLUME KNOBS Active GUITAR [max] T (Show Tuner) SHIFT+ENTER (To continue) |